Groups | Search | Server Info | Keyboard shortcuts | Login | Register [http] [https] [nntp] [nntps]

Groups > linux.kernel > #1512206 > unrolled thread

Re: [PATCH/RFT v2 09/17] regulator: fixed: Add over current event

Back to article view | Back to linux.kernel

This discussion starts older than the indexed window; earlier articles aren't shown. The article labeled Started by below is the oldest one visible, not the original post.

Contents

  Re: [PATCH/RFT v2 09/17] regulator: fixed: Add over current event Rob Herring <robh@kernel.org> - 2016-10-30 21:50 +0100

#1512206 — Re: [PATCH/RFT v2 09/17] regulator: fixed: Add over current event

On Mon, Oct 24, 2016 at 06:46:26PM +0200, ahaslam@baylibre.com wrote:
> From: Axel Haslam <ahaslam@baylibre.com>
> 
> Some regulator supplies have an over-current pin that is
> activated when the hw detects an over current condition.
> When this happens, the hardware enters a current limited
> mode.
> 
> Extend the fixed regulator driver with the ability
> to handle irq's from the over-current pin and report
> an over current event to the consumers via a regulator
> notifier. Also, add device tree bindings to allow to
> pass a gpio for over current monitoring.
> 
> Signed-off-by: Axel Haslam <ahaslam@baylibre.com>
> ---
>  .../bindings/regulator/fixed-regulator.txt         |  4 ++
>  drivers/regulator/fixed.c                          | 64 ++++++++++++++++++++++
>  include/linux/regulator/consumer.h                 |  5 ++
>  include/linux/regulator/fixed.h                    |  3 +
>  4 files changed, 76 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/regulator/fixed-regulator.txt b/Documentation/devicetree/bindings/regulator/fixed-regulator.txt
> index 4fae41d..d20bf67 100644
> --- a/Documentation/devicetree/bindings/regulator/fixed-regulator.txt
> +++ b/Documentation/devicetree/bindings/regulator/fixed-regulator.txt
> @@ -11,6 +11,8 @@ If this property is missing, the default assumed is Active low.
>  - gpio-open-drain: GPIO is open drain type.
>    If this property is missing then default assumption is false.
>  -vin-supply: Input supply name.
> +- oc-gpio: Input gpio that signals an over current condition

"-gpios" is the preferred form. So "oc-gpios".

> +- oc-active-high: The polarity of the over current pin is high

This should be specified in the gpio flags cell.

Rob

[toc] | [standalone]

Back to top | Article view | linux.kernel

csiph-web