Re: [PATCH 04/10] ARM: dts: Add MSHC2 dt node for Exynos3250 SoC

From	Krzysztof Kozlowski <k.kozlowski@samsung.com>
Newsgroups	linux.kernel
Subject	Re: [PATCH 04/10] ARM: dts: Add MSHC2 dt node for Exynos3250 SoC
Date	2016-03-14 11:00 +0100
Message-ID	<rcxs5-22b-1@gated-at.bofh.it> (permalink)
References	<rcq7g-5Io-5@gated-at.bofh.it> <rcq7g-5Io-3@gated-at.bofh.it> <rcuaS-8sW-7@gated-at.bofh.it> <rcw30-1f4-5@gated-at.bofh.it>
Organization	linux.* mail to news gateway

Show all headers | View raw

On 14.03.2016 17:28, Chanwoo Choi wrote:
> On 2016년 03월 14일 15:22, Krzysztof Kozlowski wrote:
>> On 14.03.2016 11:04, Chanwoo Choi wrote:
>>> This patch adds the MSHC2 (Mobile Storage Host Controller) Device Tree node for
>>> Exynos3250 SoC.
>>>
>>> Cc: Kukjin Kim <kgene@kernel.org>
>>> Cc: Krzysztof Kozlowski <k.kozlowski@samsung.com>
>>> Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
>>> Reviewed-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
>>> ---
>>>  arch/arm/boot/dts/exynos3250-pinctrl.dtsi | 35 +++++++++++++++++++++++++++++++
>>>  arch/arm/boot/dts/exynos3250.dtsi         | 13 ++++++++++++
>>>  2 files changed, 48 insertions(+)
>>
>>
>> After looking at your other patch ("ARM: dts: Add initial pin
>> configuration for exynos3250-rinato") I have doubts. The Monk will be
>> affected.
> 
> You're right. On monk board, this line may be not stable.
> 
>>
>> Here you are configuring all the gpk2 GPIOS for EMMC2 mode. Then on
>> Rinato you are setting it back to default non-used state. However the
>> Monk board will remain with this new configuration... so you would have
>> to add initial-state also for Monk.
> 
> OK. I'll do it.
> 
>>
>> But how about doing opposite? Configure here the pins to unused state
>> and enable them only for Artik board?
>>
>> What do you think?
> 
> I think that gpk2-[0~6] pins are fixed for MMC2 device.
> So, it is good to add the pin setting for gpk2-[0~6] to exynos3250-pinctrl.dtsi.
> 
> If mmc2 device is not used like rinato and monk board,
> we should add the initial setting as NC (not connected) pin state
> as other patch (ARM: dts: Add initial pin configuration for exynos3250-rinato).

Okay, fine to me.

BR,
Krzysztof

Back to linux.kernel | Previous | Next — Previous in thread | Find similar | Unroll thread

Thread

[PATCH 04/10] ARM: dts: Add MSHC2 dt node for Exynos3250 SoC Chanwoo Choi <cw00.choi@samsung.com> - 2016-03-14 03:10 +0100
  Re: [PATCH 04/10] ARM: dts: Add MSHC2 dt node for Exynos3250 SoC Krzysztof Kozlowski <k.kozlowski@samsung.com> - 2016-03-14 07:30 +0100
    Re: [PATCH 04/10] ARM: dts: Add MSHC2 dt node for Exynos3250 SoC Chanwoo Choi <cw00.choi@samsung.com> - 2016-03-14 09:30 +0100
      Re: [PATCH 04/10] ARM: dts: Add MSHC2 dt node for Exynos3250 SoC Krzysztof Kozlowski <k.kozlowski@samsung.com> - 2016-03-14 11:00 +0100

csiph-web