Groups | Search | Server Info | Keyboard shortcuts | Login | Register [http] [https] [nntp] [nntps]

Groups > linux.kernel > #1351959

Re: [PATCH 0/4] serial: omap: robustify for high speed transfers

Show all headers | View raw

On 02/24/2016 07:37 AM, Sekhar Nori wrote:
> On Wednesday 24 February 2016 08:50 AM, Peter Hurley wrote:
>> Just to follow-up on what Sebastian wrote.
>>
>> As he pointed out, these spurious interrupts are not timeout interrupts.
>> Since IIR_UART[0] == 1, no uart interrupt is pending.
>>
>> As he wrote, these count as spurious interrupts and trigger
>> interrupt shutdown at 100000 (unless acked as uart interrupts).
> 
> Okay, by adding a printk to where the check for UART_IIR_NO_INT is in
> omap_8250_dma_handle_irq(), I do see that UART irq handler is called
> when there is apparently no interrupt.
> 
> I don't see the error interrupt count in /proc/interrupts go up although
> the code is returning IRQ_NONE when this happens. I initially thought
> that must be because of the interrupt being IRQF_SHARED. But getting rid
> of IRQF_SHARED still does not lead to error count going up. I need to
> spend some more time to see what is going on.
> 
>> These spurious interrupts very nearly correspond 1:1 (but not quite)
>> with each dma submission. So, for example, one test run had:
>>
>>     @3Mbaud line rate
>>     195826 submits
>>     195823 completions
>>
>>     195704 spurious interrupts (ie., interrupts with IIR_UART[0] == 1)
>>          0 RLSI interrupts (no line errors) (IIR_UART == 0xc6)
>>          2 RX timeout interrupts (IIR_UART == 0xcc),
>>            one during i/o test and one at the end of i/o test
>>          6 RDI interrupts (IIR_UART == 0xc4)
>>
>> The spurious interrupts occur with nearly 1:1 correspondence at _all_
>> line rates.
>>
>> Presumbably, the 6 RDI interrupts are from too-slow submission of
>> the next DMA and the uart rx fifo has reached rx trigger level already.
>> [NOTE: we should at least be using ping-pong dma buffers for rx so that
>> there is always a next DMA buffer when the current buffer is completed].
>>
>> There is no documentation in any of the OMAP TRMs regarding RDI
>> interrupts while in DMA mode. Some guidance from TI would be appreciated.
> 
> UART interrupts triggering while UART_IIR_NO_INT is set is weird enough.
> I will check around internally with hardware folks here. Getting an
> answer might take time. But this is easily reproducible so I am
> optimistic we will get an answer soon.

Thanks.

Also, after looking over the latest errata for am335x, I was surprised
not to see an errata for our TX DMA workaround.

Currently, to get memory-to-device DMA to start *on am335x only* requires
writing the 1st byte to the UART fifo to trigger DMA, which is pretty odd.
It's almost as if the TX DMA trigger is edge-triggered rather than
level-triggered.

Let me know if you need more info.


Regards,
Peter Hurley

Back to linux.kernel | Previous | Next | Find similar | Unroll thread

Thread

Re: [PATCH 0/4] serial: omap: robustify for high speed transfers Peter Hurley <peter@hurleysoftware.com> - 2016-03-07 21:30 +0100

csiph-web