Groups > linux.kernel > #1419185

Re: [PATCH v2 4/4] dynamic_debug: add jump label support

From	Arnd Bergmann <arnd@arndb.de>
Newsgroups	linux.kernel
Subject	Re: [PATCH v2 4/4] dynamic_debug: add jump label support
Date	2016-06-10 12:00 +0200
Message-ID	<rIrol-2W0-13@gated-at.bofh.it> (permalink)
References	<rAZZT-2CA-5@gated-at.bofh.it> <rAZZT-2CA-9@gated-at.bofh.it>
Organization	linux.* mail to news gateway

Show all headers | View raw

On Friday, May 20, 2016 5:16:36 PM CEST Jason Baron wrote:
> Although dynamic debug is often only used for debug builds, sometimes its
> enabled for production builds as well. Minimize its impact by using jump
> labels. This reduces the text section by 7000+ bytes in the kernel image
> below. It does increase data, but this should only be referenced when
> changing the direction of the branches, and hence usually not in cache.
> 
>    text	   data	    bss	    dec	    hex	filename
> 8194852	4879776	 925696	14000324	 d5a0c4	vmlinux.pre
> 8187337	4960224	 925696	14073257	 d6bda9	vmlinux.post
> 
> Signed-off-by: Jason Baron <jbaron@akamai.com>
> ---

This causes problems for some of my randconfig builds, when a dynamic
debug call is used inside of an __exit function:

`.exit.text' referenced in section `__jump_table' of drivers/built-in.o: defined in discarded section `.exit.text' of drivers/built-in.o
`.exit.text' referenced in section `__jump_table' of drivers/built-in.o: defined in discarded section `.exit.text' of drivers/built-in.o

	Arnd

Back to linux.kernel | Previous | Next — Next in thread | Find similar | Unroll thread

Thread

Re: [PATCH v2 4/4] dynamic_debug: add jump label support Arnd Bergmann <arnd@arndb.de> - 2016-06-10 12:00 +0200
  Re: [PATCH v2 4/4] dynamic_debug: add jump label support Jason Baron <jbaron@akamai.com> - 2016-06-10 17:40 +0200
  Re: [PATCH v2 4/4] dynamic_debug: add jump label support Jason Baron <jbaron@akamai.com> - 2016-06-10 23:30 +0200

csiph-web