Re: Data redden

From	Paul van der Vlis <paul@vandervlis.nl>
Newsgroups	nl.comp.os.linux.techniek
Subject	Re: Data redden
Date	2024-07-03 13:41 +0200
Organization	A noiseless patient Spider
Message-ID	<v63ddl$25s1i$1@dont-email.me> (permalink)
References	<v5p872$3vlkv$1@dont-email.me> <v5pf1q$uld$1@dont-email.me> <sFz07E.uv44@a3.nl.invalid> <v63b25$25bgu$1@dont-email.me>

Show all headers | View raw

Op 03-07-2024 om 13:01 schreef Paul van der Vlis:
> Op 02-07-2024 om 02:33 schreef Adri Verhoef:
>> Op moederschip aarde schreef iemand die zich identificeerde als
>> De ongekruisigde (ds.) <deongekruisigde@invalid.invalid>:
>>> On 2024-06-29, Paul van der Vlis <paul@vandervlis.nl> wrote:
>>>> Hoi,
>>>>
>>>> Ik probeer de data te redden van een USB-disk. De vorige twee keer ging
>>>> dat goed. Maar hier verschijnt /dev/sdd alleen tijdelijk even tijdens
>>>> het starten, maar is al vrij snel weer verdwenen.
>>>>
>>>> Ik heb twee verschillende computers en kabels geprobeerd.
>>>> Zie onder output van dmesg.
>>>>
>>>> Heeft iemand nog ideeën wat ik zou kunnen doen om /dev/sdd te laten
>>>> voortbestaan, zodat ik de data eraf kan halen?
>>>
>>> Als ik die log lees dan lijkt het ding gewoon kapot (elektronisch
>>> of zo). Waarschijnlijk helaas voor de data erop.
>>>
>>>
>>>> Groet,
>>>> Paul
>>>>
>>>>
>>>> 174264.957546] usb 1-1.5: new high-speed USB device number 23 using 
>>>> ehci-pci
>>>> [174265.107849] usb 1-1.5: New USB device found, idVendor=1058,
>>>> idProduct=2620, bcdDevice=10.23
>>>> [174265.107853] usb 1-1.5: New USB device strings: Mfr=2, Product=3,
>>>> SerialNumber=1
>>>> [174265.107855] usb 1-1.5: Product: Elements 2620
>>>> [174265.107856] usb 1-1.5: Manufacturer: Western Digital
>>>> [174265.107858] usb 1-1.5: SerialNumber: 57583732443631304B365431
>>>> [174265.108279] usb-storage 1-1.5:1.0: USB Mass Storage device detected
>>>> [174265.108658] scsi host7: usb-storage 1-1.5:1.0
>>>> [174266.118725] scsi 7:0:0:0: Direct-Access     WD       Elements 2620
>>>>    1023 PQ: 0 ANSI: 6
>>>> [174266.119767] sd 7:0:0:0: Attached scsi generic sg4 type 0
>>>> [174266.123256] sd 7:0:0:0: [sdd] Spinning up disk...
>>>> [174267.141475]
>>>> .........................................................ready
>>>> [174324.485251] sd 7:0:0:0: [sdd] Very big device. Trying to use READ
>>>> CAPACITY(16).
>>>> [174324.485882] sd 7:0:0:0: [sdd] 9767475200 512-byte logical blocks:
>>>> (5.00 TB/4.55 TiB)
>>>> [174324.485885] sd 7:0:0:0: [sdd] 4096-byte physical blocks
>>>> [174324.487263] sd 7:0:0:0: [sdd] Write Protect is off
>>>> [174324.487268] sd 7:0:0:0: [sdd] Mode Sense: 47 00 10 08
>>>> [174324.488713] sd 7:0:0:0: [sdd] No Caching mode page found
>>>> [174324.488721] sd 7:0:0:0: [sdd] Assuming drive cache: write through
>>>> [174355.583306] usb 1-1.5: reset high-speed USB device number 23 using
>>>> ehci-pci
>>>> [174360.691216] usb 1-1.5: device descriptor read/64, error -110
>>>> [174376.306788] usb 1-1.5: device descriptor read/64, error -110
>>>> [174376.494792] usb 1-1.5: reset high-speed USB device number 23 using
>>>> ehci-pci
>>>> [174381.682674] usb 1-1.5: device descriptor read/64, error -110
>>>> [174397.306284] usb 1-1.5: device descriptor read/64, error -110
>>>> [174397.494297] usb 1-1.5: reset high-speed USB device number 23 using
>>>> ehci-pci
>>
>> https://askubuntu.com/questions/644010/ubuntu-cant-read-my-usb-device-descriptor-read-64-error-110
>> "The device descriptor read/64, error -110 means that USB port power 
>> supply was
>> exceeded."
>> https://stackoverflow.com/questions/13653692/device-descriptor-read-64-error-110
>> "USB error -110 means "Timeout expired before the transfer completed", 
>> which
>> could be caused by anything. Most commonly, it's because power was 
>> exceeded;
>> the host could not provide enough electric power for the pendrive to 
>> operate.
>> Because it has not enough power also the USB stick cannot provide the 
>> device
>> descriptor to the host, as a result it cannot be identified and so on. 
>> Maybe
>> your motherboard it's overloaded with devices that consume all the 
>> available
>> power."
>> "I had the same error, but with no USB device plugged in. I have a 
>> Suse 13.2
>> and 42.2 installed on an internal ssd drive in a HP ProBook 430. When 
>> I booted
>> into 42.2, I got that error and booting simply stopped there. Weird 
>> enough with
>> 13.2 on the same hard disk I could boot with no problems. Following 
>> Johnsters
>> advice to unplug any power supply including battery removal finally 
>> did it, so
>> loads of thanks go there. And to all running into this post without 
>> any obvious
>> interaction of USB devices in their problems: Try making your system 
>> voltage
>> free, it still might do the trick."
>> "Main voltage is not high enough in my home. It's below 180V (normally
>> 220-240). Sometimes I get the same error. Sometimes my PC restarts 
>> itself."
>>
>> Ik realiseer me dat dit niet per se de oplossing voor jouw probleem 
>> is, Paul,
>> het zijn slechts suggesties; misschien brengen ze je op ideeën om het 
>> probleem
>> aan te pakken.
> 
> Bedankt, ik ga hiernaar kijken...

Ik heb hem nu aan een vrij nieuwe laptop gehangen met een forse USB-C 
voeding en natuurlijk een accu. Op zich gebeurd zo ongeveer hetzelfde, 
alleen krijg ik nu error -62.

paul@laptopp:~$ grep '62' /usr/include/asm-generic/errno.h
#define	ETIME		62	/* Timer expired */
paul@laptopp:~$

Dus ook een timeout...

Fout 110 is officieel "Connextion timeout".

Groet,
Paul

-- 
Paul van der Vlis Linux systeembeheer Groningen
https://vandervlis.nl

Back to nl.comp.os.linux.techniek | Previous | Next — Previous in thread | Next in thread | Find similar

Thread

Data redden Paul van der Vlis <paul@vandervlis.nl> - 2024-06-29 17:11 +0200
  Re: Data redden "De ongekruisigde (ds.)" <ongekruisigde@gekruisigden.invalid> - 2024-06-29 17:08 +0000
    Re: Data redden a3@a3.nl.invalid (Adri Verhoef) - 2024-07-02 00:33 +0000
      Re: Data redden Ozymandias <ozymandias@ozymandias.invalid> - 2024-07-02 08:20 +0000
      Re: Data redden Paul van der Vlis <paul@vandervlis.nl> - 2024-07-03 13:01 +0200
        Re: Data redden Paul van der Vlis <paul@vandervlis.nl> - 2024-07-03 13:41 +0200
          Re: Data redden Ozymandias <ozymandias@ozymandias.invalid> - 2024-07-03 12:29 +0000
      Re: Data redden Paul van der Vlis <paul@vandervlis.nl> - 2024-07-03 13:58 +0200
        Re: Data redden a3@a3.nl.invalid (Adri Verhoef) - 2024-07-15 00:00 +0000

csiph-web