[PATCH] ARM: dts: dra7: Support QSPI MODE-0 operation at 64MHz

From	Vignesh R <vigneshr@ti.com>
Newsgroups	linux.kernel
Subject	[PATCH] ARM: dts: dra7: Support QSPI MODE-0 operation at 64MHz
Date	2016-02-25 05:50 +0100
Message-ID	<r5W2e-6YA-9@gated-at.bofh.it> (permalink)
Organization	linux.* mail to news gateway

Show all headers | View raw

According to Data Manual(SPRS915P) of AM57x, TI QSPI controller on
DRA74(rev 1.1+) can support up to 64MHz in MODE-0, whereas MODE-3 is
limited to 48MHz. Hence, switch to MODE-0 for better throughput.

Signed-off-by: Vignesh R <vigneshr@ti.com>
---
 arch/arm/boot/dts/dra7-evm.dts | 6 ++----
 1 file changed, 2 insertions(+), 4 deletions(-)

diff --git a/arch/arm/boot/dts/dra7-evm.dts b/arch/arm/boot/dts/dra7-evm.dts
index cfc24e52244e..15f10bdc8c31 100644
--- a/arch/arm/boot/dts/dra7-evm.dts
+++ b/arch/arm/boot/dts/dra7-evm.dts
@@ -653,15 +653,13 @@
 	pinctrl-names = "default";
 	pinctrl-0 = <&qspi1_pins>;
 
-	spi-max-frequency = <48000000>;
+	spi-max-frequency = <64000000>;
 	m25p80@0 {
 		compatible = "s25fl256s1";
-		spi-max-frequency = <48000000>;
+		spi-max-frequency = <64000000>;
 		reg = <0>;
 		spi-tx-bus-width = <1>;
 		spi-rx-bus-width = <4>;
-		spi-cpol;
-		spi-cpha;
 		#address-cells = <1>;
 		#size-cells = <1>;
 
-- 
2.7.1

Back to linux.kernel | Previous | Next — Next in thread | Find similar | Unroll thread

Thread

[PATCH] ARM: dts: dra7: Support QSPI MODE-0 operation at 64MHz Vignesh R <vigneshr@ti.com> - 2016-02-25 05:50 +0100
  Re: [PATCH] ARM: dts: dra7: Support QSPI MODE-0 operation at 64MHz Tony Lindgren <tony@atomide.com> - 2016-02-26 20:20 +0100
    Re: [PATCH] ARM: dts: dra7: Support QSPI MODE-0 operation at 64MHz Vignesh R <vigneshr@ti.com> - 2016-02-29 13:00 +0100

csiph-web