Groups | Search | Server Info | Keyboard shortcuts | Login | Register [http] [https] [nntp] [nntps]


Groups > sci.electronics.design > #452768

Re: How do those Spring Reverbs work in guitar amps?

From Tauno Voipio <tauno.voipio@notused.fi.invalid>
Newsgroups sci.electronics.design
Subject Re: How do those Spring Reverbs work in guitar amps?
Date 2017-03-20 21:28 +0200
Organization A noiseless patient Spider
Message-ID <oapab3$o3a$1@dont-email.me> (permalink)
References (1 earlier) <s4HzA.29030$7b3.4927@fx18.iad> <e59ca62d-d637-4049-bb2f-b445d86a3e1e@googlegroups.com> <YNHzA.87899$qD6.33035@fx34.iad> <a87e43f3-7579-4936-a363-9acc9cae3613@googlegroups.com> <LVVzA.129389$IM7.91533@fx39.iad>

Show all headers | View raw


On 20.3.17 21:18, bitrex wrote:
> On 03/19/2017 11:32 PM, Phil Allison wrote:
>> bitrex wrote:
>>
>>> On 03/19/2017 10:52 PM, Phil Allison wrote:
>>>
>>>> The input coil used has a nominal impedance of 8 ohms at 1kHz, much
>>>> lower at 100Hz and much higher at 10kHz.
>>>>
>>>> Drive power requirement is around 10mW, some as other designs, but
>>>> the low impedance means it cannot be driven fully by a single,
>>>> regular op-amp.
>>>
>>> That makes sense. How much average voltage would one expect to see
>>> between terminals 4 and 5 of the tank input prior to the unit distorting
>>> with a guitar signal?
>>>
>>
>>   ** 500mV rms maybe.
>
> Any of them ever use push-pull to drive the transducer? That is to say,
> not push-pull in the way a regular complimentary output amplifier or
> op-amp is, but say a bridged configuration of two op-amps driven
> out-of-phase.
>
> I had wanted to drive an inductive load with a varying impedance over
> frequency with a bridge configuration to put more power into it than
> what the supply could provide single-ended, but couldn't figure out the
> proper sense topology so both amps could provide current drive over the
> whole cycle.


If you look at the schematics, you'll notice that the feedback
is taken from the coil current, rather than voltage. For a bridge
amplifier, you'd need more complicated way of picking up the
feedback signal. Besides, a simple complementary 2n3904/2n3906
would be enough (or a LM386).

-- 

-TV

Back to sci.electronics.design | Previous | Next — Previous in thread | Next in thread | Find similar | Unroll thread


Thread

How do those Spring Reverbs work in guitar amps? oldschool@tubes.com - 2017-03-18 19:12 -0500
  Re: How do those Spring Reverbs work in guitar amps? rickman <gnuarm@gmail.com> - 2017-03-18 20:47 -0400
    Re: How do those Spring Reverbs work in guitar amps? Phil Allison <pallison49@gmail.com> - 2017-03-18 18:11 -0700
  Re: How do those Spring Reverbs work in guitar amps? Phil Allison <pallison49@gmail.com> - 2017-03-18 18:08 -0700
    Re: How do those Spring Reverbs work in guitar amps? Don Kuenz <g@crcomp.net> - 2017-03-19 05:08 +0000
      Re: How do those Spring Reverbs work in guitar amps? Phil Allison <pallison49@gmail.com> - 2017-03-18 22:38 -0700
        Re: How do those Spring Reverbs work in guitar amps? jurb6006@gmail.com - 2017-03-19 02:46 -0700
          Re: How do those Spring Reverbs work in guitar amps? Phil Allison <pallison49@gmail.com> - 2017-03-19 04:25 -0700
            Re: How do those Spring Reverbs work in guitar amps? jurb6006@gmail.com - 2017-03-19 06:01 -0700
            Re: How do those Spring Reverbs work in guitar amps? jurb6006@gmail.com - 2017-03-19 07:46 -0700
      Re: How do those Spring Reverbs work in guitar amps? "Dave M" <dgminala@mediacombb.net> - 2017-03-19 22:49 -0500
        Re: How do those Spring Reverbs work in guitar amps? Phil Allison <pallison49@gmail.com> - 2017-03-19 22:31 -0700
          Re: How do those Spring Reverbs work in guitar amps? "Michael A. Terrell" <mike.terrell@earthlink.net> - 2017-03-23 19:01 -0400
            Re: How do those Spring Reverbs work in guitar amps? Phil Allison <pallison49@gmail.com> - 2017-03-23 16:24 -0700
              Re: How do those Spring Reverbs work in guitar amps? "dcaster@krl.org" <dcaster@krl.org> - 2017-03-23 16:37 -0700
                Re: How do those Spring Reverbs work in guitar amps? Phil Allison <pallison49@gmail.com> - 2017-03-23 17:46 -0700
                Re: How do those Spring Reverbs work in guitar amps? "dcaster@krl.org" <dcaster@krl.org> - 2017-03-23 18:05 -0700
                Re: How do those Spring Reverbs work in guitar amps? "Michael A. Terrell" <mike.terrell@earthlink.net> - 2017-03-25 03:18 -0400
              Re: How do those Spring Reverbs work in guitar amps? "Michael A. Terrell" <mike.terrell@earthlink.net> - 2017-03-25 03:16 -0400
          Re: How do those Spring Reverbs work in guitar amps? Jasen Betts <jasen@xnet.co.nz> - 2017-03-26 19:36 +0000
        Re: How do those Spring Reverbs work in guitar amps? oldschool@tubes.com - 2017-03-20 14:04 -0500
          Re: How do those Spring Reverbs work in guitar amps? Don Kuenz <g@crcomp.net> - 2017-03-21 17:22 +0000
        Re: How do those Spring Reverbs work in guitar amps? Don Kuenz <g@crcomp.net> - 2017-03-20 19:27 +0000
    Re: How do those Spring Reverbs work in guitar amps? George Herold <gherold@teachspin.com> - 2017-03-20 12:24 -0700
      Re: How do those Spring Reverbs work in guitar amps? Clifford Heath <no.spam@please.net> - 2017-03-21 09:14 +1100
        Re: How do those Spring Reverbs work in guitar amps? George Herold <gherold@teachspin.com> - 2017-03-20 17:04 -0700
          Re: How do those Spring Reverbs work in guitar amps? "dcaster@krl.org" <dcaster@krl.org> - 2017-03-20 20:06 -0700
            Re: How do those Spring Reverbs work in guitar amps? jurb6006@gmail.com - 2017-03-21 00:18 -0700
            Re: How do those Spring Reverbs work in guitar amps? George Herold <gherold@teachspin.com> - 2017-03-21 05:55 -0700
              Re: How do those Spring Reverbs work in guitar amps? "dcaster@krl.org" <dcaster@krl.org> - 2017-03-21 06:46 -0700
      Re: How do those Spring Reverbs work in guitar amps? Phil Hobbs <pcdhSpamMeSenseless@electrooptical.net> - 2017-03-21 03:15 -0400
  Re: How do those Spring Reverbs work in guitar amps? bitrex <bitrex@de.lete.earthlink.net> - 2017-03-19 22:25 -0400
    Re: How do those Spring Reverbs work in guitar amps? Phil Allison <pallison49@gmail.com> - 2017-03-19 19:52 -0700
      Re: How do those Spring Reverbs work in guitar amps? bitrex <bitrex@de.lete.earthlink.net> - 2017-03-19 23:14 -0400
        Re: How do those Spring Reverbs work in guitar amps? bitrex <bitrex@de.lete.earthlink.net> - 2017-03-19 23:14 -0400
        Re: How do those Spring Reverbs work in guitar amps? Phil Allison <pallison49@gmail.com> - 2017-03-19 20:32 -0700
          Re: How do those Spring Reverbs work in guitar amps? bitrex <bitrex@de.lete.earthlink.net> - 2017-03-20 00:01 -0400
            Re: How do those Spring Reverbs work in guitar amps? Phil Allison <pallison49@gmail.com> - 2017-03-19 22:32 -0700
          Re: How do those Spring Reverbs work in guitar amps? jurb6006@gmail.com - 2017-03-20 03:52 -0700
          Re: How do those Spring Reverbs work in guitar amps? bitrex <bitrex@de.lete.earthlink.net> - 2017-03-20 15:18 -0400
            Re: How do those Spring Reverbs work in guitar amps? Tauno Voipio <tauno.voipio@notused.fi.invalid> - 2017-03-20 21:28 +0200
              Re: How do those Spring Reverbs work in guitar amps? bitrex <bitrex@de.lete.earthlink.net> - 2017-03-20 16:26 -0400

csiph-web