Groups | Search | Server Info | Keyboard shortcuts | Login | Register [http] [https] [nntp] [nntps]

Groups > linux.kernel > #1711777 > unrolled thread

Re: [1/2] dt-bindings: watchdog: aspeed: External reset signal properties

Back to article view | Back to linux.kernel

This discussion starts older than the indexed window; earlier articles aren't shown. The article labeled Started by below is the oldest one visible, not the original post.

Contents

  Re: [1/2] dt-bindings: watchdog: aspeed: External reset signal  properties Guenter Roeck <linux@roeck-us.net> - 2017-08-15 04:30 +0200

#1711777 — Re: [1/2] dt-bindings: watchdog: aspeed: External reset signal properties

On Wed, Aug 02, 2017 at 02:15:28PM +0930, Andrew Jeffery wrote:
> For the AST2500 and compatible watchdog controllers the external reset
> signal can be configured for push-pull or open-drain drive types, and in
> the case of push-pull driving, active low or high.
> 
> Signed-off-by: Andrew Jeffery <andrew@aj.id.au>
> Acked-by: Rob Herring <robh@kernel.org>

Reviewed-by: Guenter Roeck <linux@roeck-us.net>

> ---
>  Documentation/devicetree/bindings/watchdog/aspeed-wdt.txt | 10 +++++++++-
>  1 file changed, 9 insertions(+), 1 deletion(-)
> 
> diff --git a/Documentation/devicetree/bindings/watchdog/aspeed-wdt.txt b/Documentation/devicetree/bindings/watchdog/aspeed-wdt.txt
> index 2b34ce9b60b9..c5077a1f5cb3 100644
> --- a/Documentation/devicetree/bindings/watchdog/aspeed-wdt.txt
> +++ b/Documentation/devicetree/bindings/watchdog/aspeed-wdt.txt
> @@ -33,10 +33,18 @@ Optional properties:
>          - none: No reset is performed on timeout. Assumes another watchdog
>                  engine is responsible for this.
>  
> + - aspeed,alt-boot:    If property is present then boot from alternate block.
>   - aspeed,external-signal: If property is present then signal is sent to
>  			external reset counter (only WDT1 and WDT2). If not
>  			specified no external signal is sent.
> - - aspeed,alt-boot:    If property is present then boot from alternate block.
> + - aspeed,ext-pulse-duration: External signal pulse duration in microseconds
> +
> +Optional properties for AST2500-compatible watchdogs:
> + - aspeed,ext-push-pull: If aspeed,external-signal is present, set the pin's
> +			 drive type to push-pull. The default is open-drain.
> + - aspeed,ext-active-high: If aspeed,external-signal is present and and the pin
> +			   is configured as push-pull, then set the pulse
> +			   polarity to active-high. The default is active-low.
>  
>  Example:
>  

[toc] | [standalone]

Back to top | Article view | linux.kernel

csiph-web