Groups | Search | Server Info | Keyboard shortcuts | Login | Register [http] [https] [nntp] [nntps]

Groups > linux.kernel > #1620936 > unrolled thread

Re: [PATCH net-next v2] bindings: net: stmmac: add missing note about LPI interrupt

Back to article view | Back to linux.kernel

This discussion starts older than the indexed window; earlier articles aren't shown. The article labeled Started by below is the oldest one visible, not the original post.

Contents

  Re: [PATCH net-next v2] bindings: net: stmmac: add missing note about  LPI interrupt Giuseppe CAVALLARO <peppe.cavallaro@st.com> - 2017-04-11 08:10 +0200

#1620936 — Re: [PATCH net-next v2] bindings: net: stmmac: add missing note about LPI interrupt

Hi Niklas

On 4/10/2017 9:43 AM, Niklas Cassel wrote:
> From: Niklas Cassel <niklas.cassel@axis.com>
>
> The hardware has a LPI interrupt.
> There is already code in the stmmac driver to parse and handle the
> interrupt. However, this information was missing from the DT binding.

i wonder if we could improve the comments in this patch too
> Signed-off-by: Niklas Cassel <niklas.cassel@axis.com>
> ---
>   Documentation/devicetree/bindings/net/stmmac.txt | 8 ++++----
>   1 file changed, 4 insertions(+), 4 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/net/stmmac.txt b/Documentation/devicetree/bindings/net/stmmac.txt
> index f652b0c384ce..84e4cbfd3b0f 100644
> --- a/Documentation/devicetree/bindings/net/stmmac.txt
> +++ b/Documentation/devicetree/bindings/net/stmmac.txt
> @@ -8,8 +8,8 @@ Required properties:
>     that services interrupts for this device
>   - interrupts: Should contain the STMMAC interrupts
>   - interrupt-names: Should contain the interrupt names "macirq"
> -  "eth_wake_irq" if this interrupt is supported in the "interrupts"
> -  property
> +  "eth_wake_irq" if this interrupt is supported in the "interrupts" property
this is the PMT interrupt to manage the remote wake-up packet detection
> +  "eth_lpi" if this interrupt is supported in the "interrupts" property
This is the interrupt that occurs when Tx or Rx enter/exit from LPI state

Regards
Peppe
>   - phy-mode: See ethernet.txt file in the same directory.
>   - snps,reset-gpio 	gpio number for phy reset.
>   - snps,reset-active-low boolean flag to indicate if phy reset is active low.
> @@ -152,8 +152,8 @@ Examples:
>   		compatible = "st,spear600-gmac";
>   		reg = <0xe0800000 0x8000>;
>   		interrupt-parent = <&vic1>;
> -		interrupts = <24 23>;
> -		interrupt-names = "macirq", "eth_wake_irq";
> +		interrupts = <24 23 22>;
> +		interrupt-names = "macirq", "eth_wake_irq", "eth_lpi";
>   		mac-address = [000000000000]; /* Filled in by U-Boot */
>   		max-frame-size = <3800>;
>   		phy-mode = "gmii";

[toc] | [standalone]

Back to top | Article view | linux.kernel

csiph-web