Groups | Search | Server Info | Keyboard shortcuts | Login | Register [http] [https] [nntp] [nntps]

Groups > linux.kernel > #1552479 > unrolled thread

[PATCH 2/3] dt-bindings: Input: Add enable-gpios to pwm-beeper

Back to article view | Back to linux.kernel

This discussion starts older than the indexed window; earlier articles aren't shown. The article labeled Started by below is the oldest one visible, not the original post.

Contents

  [PATCH 2/3] dt-bindings: Input: Add enable-gpios to pwm-beeper David Lechner <david@lechnology.com> - 2017-01-06 03:50 +0100

#1552479 — [PATCH 2/3] dt-bindings: Input: Add enable-gpios to pwm-beeper

This adds an optional enable-gpios property to pwm-beeper. This gpio is
used to enable the beeper. For example, the beeper may have an amplifier
that needs to be switched on.

Signed-off-by: David Lechner <david@lechnology.com>
---
 Documentation/devicetree/bindings/input/pwm-beeper.txt | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/Documentation/devicetree/bindings/input/pwm-beeper.txt b/Documentation/devicetree/bindings/input/pwm-beeper.txt
index be332ae..1c6bcf8 100644
--- a/Documentation/devicetree/bindings/input/pwm-beeper.txt
+++ b/Documentation/devicetree/bindings/input/pwm-beeper.txt
@@ -5,3 +5,14 @@ Registers a PWM device as beeper.
 Required properties:
 - compatible: should be "pwm-beeper"
 - pwms: phandle to the physical PWM device
+
+Optional properties:
+- enable-gpios: phandle to gpio to enable the beeper
+
+Example:
+
+beeper {
+	compatible = "pwm-beeper";
+	pwms = <&pwm0>;
+	enable-gpios = <&gpio0 1 GPIO_ACTIVE_LOW>;
+};
-- 
2.7.4

[toc] | [standalone]

Back to top | Article view | linux.kernel

csiph-web