Groups | Search | Server Info | Keyboard shortcuts | Login | Register [http] [https] [nntp] [nntps]

Groups > linux.kernel > #1390872 > unrolled thread

Re: [PATCH 4/4] pinctrl: iproc: Allow PINCONF to be disabled completely

Back to article view | Back to linux.kernel

This discussion starts older than the indexed window; earlier articles aren't shown. The article labeled Started by below is the oldest one visible, not the original post.

Contents

  Re: [PATCH 4/4] pinctrl: iproc: Allow PINCONF to be disabled completely Linus Walleij <linus.walleij@linaro.org> - 2016-04-29 10:50 +0200

#1390872 — Re: [PATCH 4/4] pinctrl: iproc: Allow PINCONF to be disabled completely

On Mon, Apr 18, 2016 at 9:30 PM, Ray Jui <ray.jui@broadcom.com> wrote:
> On 4/15/2016 1:24 AM, Linus Walleij wrote:
>>
>> On Wed, Apr 13, 2016 at 2:15 AM, Ray Jui <ray.jui@broadcom.com> wrote:
>>
>>> In some of the future iProc based SoCs, pinconf is handled by another
>>> block and the iProc GPIO controller is solely used as a GPIO controller.
>>> This patch adds support of a new compatible string
>>> "brcm,iproc-gpio-only",
>>> that is introduced to handle this case, where pinconf functions in this
>>> driver are completely disabled
>>>
>>> Signed-off-by: Ray Jui <ray.jui@broadcom.com>
>>> Reviewed-by: Yendapally Reddy Dhananjaya Reddy
>>> <yendapally.reddy@broadcom.com>
>>> Reviewed-by: Jon Mason <jon.mason@broadcom.com>
>>> Reviewed-by: Scott Branden <scott.branden@broadcom.com>
>>
>>
>> If this was entirely true, then the driver should end up only executing
>> [devm_]gpiochip_add_data() but that does not seem to be the case.
>
> Yes, in the case of compatible string "brcm,iproc-gpio-only" is detected,
> the driver only registers 'gpiochip_add_data'. Please check patch 2/4 of
> this series, which takes care of it.

OK.

>> You are still registering a pin controller, right? Just disabling some of
>> the pin config options. The pin multiplexing is still there, right?
>> Then it is not "solely a GPIO controller". Not at all.
>
> This driver does not register itself as a PINCONF driver if
> "brcm,iproc-gpio-only" compatible string is detected. This is addressed in
> patch 2/4 of this series.
>
> Pin based IOMUX GPIO override is only activated when
> 'chip->pinmux_is_supported' is true, and it is only true if the optional DT
> property "gpio-ranges" is defined.

OK.

> I believe the current issue with this patch series is now only on the naming
> of the new compatible string "brcm,iproc-gpio-only". Please correct me if
> I'm wrong.

Yeah I think I get it now. The patch set makes sense.
Looking forward to the next iteration!

Yours,
Linus Walleij

[toc] | [standalone]

Back to top | Article view | linux.kernel

csiph-web