Groups | Search | Server Info | Keyboard shortcuts | Login | Register [http] [https] [nntp] [nntps]
Groups > linux.kernel > #1686329
| From | Marc Zyngier <marc.zyngier@arm.com> |
|---|---|
| Newsgroups | linux.kernel |
| Subject | Re: [PATCH 0/2] Workaround for uPD72020x USB3 chips |
| Date | 2017-07-13 09:50 +0200 |
| Message-ID | <u2H2O-2IC-23@gated-at.bofh.it> (permalink) |
| References | <u1Jgm-6Vr-23@gated-at.bofh.it> <u2CPw-9i-5@gated-at.bofh.it> <u2G6K-2a4-21@gated-at.bofh.it> |
| Organization | ARM Ltd |
On 13/07/17 07:48, Ard Biesheuvel wrote: > On 13 July 2017 at 04:12, Bjorn Helgaas <helgaas@kernel.org> wrote: >> On Mon, Jul 10, 2017 at 04:52:28PM +0100, Marc Zyngier wrote: >>> Ard and myself have just spent quite some time lately trying to pin >>> down an issue in the DMA code which was taking the form of a PCIe USB3 >>> controller issuing a DMA access at some bizarre address, and being >>> caught red-handed by the IOMMU. >>> >>> After much head scratching and most of a week-end spent on tracing the >>> damn thing, I'm now convinced that the DMA code is fine, the XHCI >>> driver is correct, but that the HW (a Renesas uPD720202 chip) is a >>> nasty piece of work. >>> >>> The issue is as follow: >>> >>> - EFI initializes the controller using physical addresses above the >>> 4GB limit (this is on an arm64 box where the memory starts at >>> 0x80_00000000...). >>> >>> - The kernel takes over, sends a XHCI reset to the controller, and >>> because we have an IOMMU sitting between the controller and memory, >>> provides *virtual* addresses. Trying to make things a bit faster for >>> our controller, it issues IOVAs in the low 4GB range). >>> >>> - Low and behold, the controller is now issuing transactions with a >>> 0x80 prefix in front of our IOVA. Yes, the same prefix that was >>> programmed during the EFI configuration. IOMMU fault, not happy. >>> >>> If the kernel is hacked to only generate IOVAs that are more than >>> 32bit wide, the HW behaves correctly. The only way I can explain this >>> behaviour is that the HW latches the top 32bit of the ERST (it is >>> always the ERST IOVA that appears in my traces) in some internal >>> register, and that the XHCI reset fails to clear it. Writing zero in >>> the top bits is not enough to clear it either. >>> >>> So far, the only solution we have for this lovely piece of kit is to >>> force a PCI reset at probe time, which puts it right. The patches are >>> pretty ugly, but that's the best I could come up with so far. >>> >>> Tested on a pair of AMD Opteron 1100 boxes with Renesas uPD720201 and >>> uPD720202 controllers. >>> >>> Marc Zyngier (2): >>> PCI: Implement pci_reset_function_locked >>> usb: host: pci_quirks: Force hard reset of Renesas uPD72020x USB >>> controller >>> >>> drivers/pci/pci.c | 35 +++++++++++++++++++++++++++++++++++ >>> drivers/usb/host/pci-quirks.c | 20 ++++++++++++++++++++ >>> drivers/usb/host/pci-quirks.h | 1 + >>> drivers/usb/host/xhci-pci.c | 7 +++++++ >>> include/linux/pci.h | 1 + >>> 5 files changed, 64 insertions(+) >> >> I provisionally applied this to pci/virtualization. I'd like to have an >> XHCI ack before going further, though. >> >> I assume this only affects boxes where the firmware uses addresses above >> 4GB, i.e., not very many? So this is v4.14 material? Or do you think it's >> important for v4.13? >> > > As I mentioned, it would be nice if this could at least go into v4.11 > and later, given that v4.11 contains a patch that switches all PCI > devices to 32-bit addressing only when the IOMMU is involved in DMA, > and this is what triggered the issue on arm64 boards with such a PCI > card and no DRAM below 4 GB. Agreed. It is likely that the issue will trigger on any 64bit->32bit IOVA transition, not only EFI->kernel, such as a kexec from a 4.10 to a 4.11 kernel. More importantly, this could have a dramatic effect on a system where both the 32bit and 64bit address ranges are valid. In my case, I was saved by the IOMMU blocking the DMA access, but imagine for a second the device was using PAs... I'm not sure that this is completely hypothetical, nor arm64 specific. Thanks, M. -- Jazz is not dead. It just smells funny...
Back to linux.kernel | Previous | Next — Previous in thread | Next in thread | Find similar | Unroll thread
[PATCH 0/2] Workaround for uPD72020x USB3 chips Marc Zyngier <marc.zyngier@arm.com> - 2017-07-10 18:00 +0200
[PATCH 1/2] PCI: Implement pci_reset_function_locked Marc Zyngier <marc.zyngier@arm.com> - 2017-07-10 18:00 +0200
Re: [PATCH 0/2] Workaround for uPD72020x USB3 chips Ard Biesheuvel <ard.biesheuvel@linaro.org> - 2017-07-10 19:30 +0200
Re: [PATCH 0/2] Workaround for uPD72020x USB3 chips Ard Biesheuvel <ard.biesheuvel@linaro.org> - 2017-07-12 21:10 +0200
Re: [PATCH 0/2] Workaround for uPD72020x USB3 chips Bjorn Helgaas <helgaas@kernel.org> - 2017-07-13 05:20 +0200
Re: [PATCH 0/2] Workaround for uPD72020x USB3 chips Ard Biesheuvel <ard.biesheuvel@linaro.org> - 2017-07-13 08:50 +0200
Re: [PATCH 0/2] Workaround for uPD72020x USB3 chips Marc Zyngier <marc.zyngier@arm.com> - 2017-07-13 09:50 +0200
Re: [PATCH 0/2] Workaround for uPD72020x USB3 chips Bjorn Helgaas <helgaas@kernel.org> - 2017-07-13 13:40 +0200
Re: [PATCH 0/2] Workaround for uPD72020x USB3 chips Marc Zyngier <marc.zyngier@arm.com> - 2017-07-13 14:20 +0200
Re: [PATCH 0/2] Workaround for uPD72020x USB3 chips Greg Kroah-Hartman <gregkh@linuxfoundation.org> - 2017-07-13 10:30 +0200
Re: [PATCH 0/2] Workaround for uPD72020x USB3 chips Bjorn Helgaas <helgaas@kernel.org> - 2017-07-13 13:40 +0200
csiph-web