[PATCH] dt-bindings: power: New bindings for ltc3651-charger

Path	csiph.com!news.redatomik.org!aioe.org!news.servidellagleba.it!bofh.it!news.nic.it!robomod
From	Mike Looijmans <mike.looijmans@topic.nl>
Newsgroups	linux.kernel
Subject	[PATCH] dt-bindings: power: New bindings for ltc3651-charger
Date	Fri, 05 May 2017 08:40:02 +0200
Message-ID	<tDF4e-6re-17@gated-at.bofh.it> (permalink)
X-Original-To	devicetree@vger.kernel.org
X-Tcpremoteip	37.74.225.130
X-Authenticated-Uid	mike@milosoftware.com
X-Mailer	git-send-email 1.9.1
Sender	robomod@news.nic.it
List-ID	<linux-kernel.vger.kernel.org>
X-Mailing-List	linux-kernel@vger.kernel.org
Approved	robomod@news.nic.it
Lines	42
Organization	linux.* mail to news gateway
X-Original-Cc	sre@kernel.org, linux-pm@vger.kernel.org, linux-kernel@vger.kernel.org, robh+dt@kernel.org, mark.rutland@arm.com, Mike Looijmans <mike.looijmans@topic.nl>
X-Original-Date	Fri, 5 May 2017 08:38:35 +0200
X-Original-Message-ID	<1493966315-15893-1-git-send-email-mike.looijmans@topic.nl>
X-Original-Sender	linux-kernel-owner@vger.kernel.org
Xref	csiph.com linux.kernel:1636193

Show key headers only | View raw

This adds the devicetree bindings documentation for the LTC3651 battery charger.

Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
---
 .../bindings/power/supply/ltc3651-charger.txt      | 26 ++++++++++++++++++++++
 1 file changed, 26 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt

diff --git a/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt b/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt
new file mode 100644
index 0000000..a7dd80f
--- /dev/null
+++ b/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt
@@ -0,0 +1,26 @@
+ltc3651-charger
+
+Required properties:
+ - compatible: "lltc,ltc3651-charger"
+ - acpr-gpios: Connect to ACPR output. See remark below.
+
+Optional properties:
+ - fault-gpios: Connect to FAULT output. See remark below.
+ - chrg-gpios: Connect to CHRG output. See remark below.
+
+The ltc3651 outputs are open-drain type and active low. The driver assumes the
+GPIO reports "active" when the output is asserted, so if the pins have been
+connected directly, the GPIO flags should be set to active low also.
+
+The driver will attempt to aquire interrupts for all GPIOs. If the system is
+not capabale of providing that, the driver cannot report changes and userspace
+will need to periodically read the sysfs attributes to detect changes.
+
+Example:
+
+	charger: battery-charger {
+		compatible = "lltc,ltc3651-charger";
+		acpr-gpios = <&gpio0 68 GPIO_ACTIVE_LOW>;
+		fault-gpios = <&gpio0 64 GPIO_ACTIVE_LOW>;
+		chrg-gpios = <&gpio0 63 GPIO_ACTIVE_LOW>;
+	};
-- 
1.9.1

Back to linux.kernel | Previous | Next — Next in thread | Find similar | Unroll thread

Thread

[PATCH] dt-bindings: power: New bindings for ltc3651-charger Mike Looijmans <mike.looijmans@topic.nl> - 2017-05-05 08:40 +0200
  Re: [PATCH] dt-bindings: power: New bindings for ltc3651-charger Rob Herring <robh@kernel.org> - 2017-05-08 19:20 +0200
    [PATCH v2] dt-bindings: power: New bindings for ltc3651-charger Mike Looijmans <mike.looijmans@topic.nl> - 2017-05-09 07:40 +0200
    Re: [PATCH] dt-bindings: power: New bindings for ltc3651-charger Mike Looijmans <mike.looijmans@topic.nl> - 2017-05-09 07:50 +0200

csiph-web