Re: [PATCH 3/3] ARM: dts: sun8i-h3: Add dts file for Sinovoip BPI-M2+

From	Maxime Ripard <maxime.ripard@free-electrons.com>
Newsgroups	linux.kernel
Subject	Re: [PATCH 3/3] ARM: dts: sun8i-h3: Add dts file for Sinovoip BPI-M2+
Date	2016-06-07 22:50 +0200
Message-ID	<rHw6L-7py-47@gated-at.bofh.it> (permalink)
References	<rFvHQ-35T-11@gated-at.bofh.it> <rFvHQ-35T-23@gated-at.bofh.it>
Organization	linux.* mail to news gateway

Show all headers | View raw

[Multipart message — attachments visible in raw view] - view raw

On Thu, Jun 02, 2016 at 03:50:11PM +0800, Chen-Yu Tsai wrote:
> The BPI-M2+ is an H3 development board. It is a smaller form factor than
> the original BPI-M2, with the new H3 SoC.
> 
> It has 1GB DRAM, 8GB eMMC, a micro SD card slot, HDMI output, 2 USB
> host connector and 1 USB OTG connector, an IR receiver, WiFi+BT based
> on Ampak AP6212.
> 
> The board also has a 3 pin header for (debug) UART, a 40 pin GPIO header
> based on the Raspberry Pi B+, but the peripheral signals are not the
> same, and an FPC connector for connecting BPI's camera.
> 
> Signed-off-by: Chen-Yu Tsai <wens@csie.org>

I fixed the whitespace error, and applied all three.

Thanks!
Maxime

-- 
Maxime Ripard, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com

Back to linux.kernel | Previous | Next — Previous in thread | Find similar | Unroll thread

Thread

[PATCH 3/3] ARM: dts: sun8i-h3: Add dts file for Sinovoip BPI-M2+ Chen-Yu Tsai <wens@csie.org> - 2016-06-02 10:00 +0200
  Re: [PATCH 3/3] ARM: dts: sun8i-h3: Add dts file for Sinovoip BPI-M2+ Maxime Ripard <maxime.ripard@free-electrons.com> - 2016-06-07 22:50 +0200

csiph-web