Groups | Search | Server Info | Keyboard shortcuts | Login | Register [http] [https] [nntp] [nntps]

Groups > linux.kernel > #1208296

Re: [RFC PATCH v5 1/9] mmc: dw_mmc: Add external dma interface support

Show all headers | View raw

在 2015/8/15 6:13, Heiko Stübner 写道:
> Hi Shawn,
>
> Am Freitag, 14. August 2015, 16:34:35 schrieb Shawn Lin:
>> DesignWare MMC Controller can supports two types of DMA
>> mode: external dma and internal dma. We get a RK312x platform
>> integrated dw_mmc and ARM pl330 dma controller. This patch add
>> edmac ops to support these platforms. I've tested it on RK312x
>> platform with edmac mode and RK3288 platform with idmac mode.
>>
>> Signed-off-by: Shawn Lin <shawn.lin@rock-chips.com>
>
> judging by your "from", I guess you're running this on some older Rockchip soc
> without the idma? Because I tried testing this on a Radxa Rock, but only got
> failures, from the start (failed to read card status register). In PIO mode
> everything works again.
>
>
> I guess I overlooked just some tiny detail, but to me the dma channel ids seem
> correct after all. Maybe you have any hints what I'm doing wrong?
>

Thanks, HeiKo.

yes, I'm running a quite older low-end Rockchip soc w/o idma.

Hmm... from your failure to read CSR, I think generic DMA of Radxa Rock 
was not runing properly. Your dma channel ids is correct, but it 
certainly work on my platform。 I will try to find a Radxa Rock to 
re-test my patch ASAP.



> diff --git a/arch/arm/boot/dts/rk3xxx.dtsi b/arch/arm/boot/dts/rk3xxx.dtsi
> index 4497d28..92d7156 100644
> --- a/arch/arm/boot/dts/rk3xxx.dtsi
> +++ b/arch/arm/boot/dts/rk3xxx.dtsi
> @@ -217,6 +217,8 @@
>                  interrupts = <GIC_SPI 23 IRQ_TYPE_LEVEL_HIGH>;
>                  clocks = <&cru HCLK_SDMMC>, <&cru SCLK_SDMMC>;
>                  clock-names = "biu", "ciu";
> +             dmas = <&dmac2 1>;
> +             dma-names = "rx-tx";
>                  fifo-depth = <256>;
>                  status = "disabled";
>          };
> @@ -227,6 +229,8 @@
>                  interrupts = <GIC_SPI 24 IRQ_TYPE_LEVEL_HIGH>;
>                  clocks = <&cru HCLK_SDIO>, <&cru SCLK_SDIO>;
>                  clock-names = "biu", "ciu";
> +             dmas = <&dmac2 3>;
> +             dma-names = "rx-tx";
>                  fifo-depth = <256>;
>                  status = "disabled";
>          };
> @@ -237,6 +241,8 @@
>                  interrupts = <GIC_SPI 25 IRQ_TYPE_LEVEL_HIGH>;
>                  clocks = <&cru HCLK_EMMC>, <&cru SCLK_EMMC>;
>                  clock-names = "biu", "ciu";
> +             dmas = <&dmac2 4>;
> +             dma-names = "rx-tx";
>                  fifo-depth = <256>;
>                  status = "disabled";
>          };
>
>
> [...]
>
>> diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
>> index fcbf552..e01ead3 100644
>> --- a/drivers/mmc/host/dw_mmc.c
>> +++ b/drivers/mmc/host/dw_mmc.c
>> @@ -2517,8 +2642,23 @@ static void dw_mci_cleanup_slot(struct dw_mci_slot
>> *slot, unsigned int id) static void dw_mci_init_dma(struct dw_mci *host)
>>   {
>>   	int addr_config;
>> +	int trans_mode;
>> +	struct device *dev = host->dev;
>> +	struct device_node *np = dev->of_node;
>> +
>> +	/* Check tansfer mode */
>> +	trans_mode = SDMMC_GET_TRANS_MODE(mci_readl(host, HCON));
>> +	if (trans_mode == 0) {
>> +		trans_mode = TRANS_MODE_IDMAC;
>> +	} else if (trans_mode == 1 || trans_mode == 2) {
>> +		trans_mode = TRANS_MODE_EDMAC;
>> +	} else {
>> +		trans_mode = TRANS_MODE_PIO;
>> +		goto no_dma;
>> +	}
>> +
>>   	/* Check ADDR_CONFIG bit in HCON to find IDMAC address bus width */
>> -	addr_config = (mci_readl(host, HCON) >> 27) & 0x01;
>> +	addr_config = SDMMC_GET_ADDR_CONFIG(mci_readl(host, HCON));
>>
>>   	if (addr_config == 1) {
>>   		/* host supports IDMAC in 64-bit address mode */
>
> I guess the idmac address size checking block
>
>          /* Check ADDR_CONFIG bit in HCON to find IDMAC address bus width */
>          addr_config = SDMMC_GET_ADDR_CONFIG(mci_readl(host, HCON));
>
>          if (addr_config == 1) {
>                  /* host supports IDMAC in 64-bit address mode */
>                  host->dma_64bit_address = 1;
>                  dev_info(host->dev, "IDMAC supports 64-bit address mode.\n");
>                  if (!dma_set_mask(host->dev, DMA_BIT_MASK(64)))
>                          dma_set_coherent_mask(host->dev, DMA_BIT_MASK(64));
>          } else {
>                  /* host supports IDMAC in 32-bit address mode */
>                  host->dma_64bit_address = 0;
>                  dev_info(host->dev, "IDMAC supports 32-bit address mode.\n");
>          }
>
> could either live inside the trans_mode == 0 conditional above or get its own
> if (trans_mode == 0) conditional. Either way I guess it should not talk about
> idmac when either pio or extdmac are used.
>
>
> Thanks
> Heiko
>
>
>


-- 
Shawn Lin

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

Back to linux.kernel | Previous | Next — Previous in thread | Find similar | Unroll thread

Thread

[RFC PATCH v5 1/9] mmc: dw_mmc: Add external dma interface support Shawn Lin <shawn.lin@rock-chips.com> - 2015-08-14 10:40 +0200
  Re: [RFC PATCH v5 1/9] mmc: dw_mmc: Add external dma interface support Heiko Stübner <heiko@sntech.de> - 2015-08-15 00:20 +0200
    Re: [RFC PATCH v5 1/9] mmc: dw_mmc: Add external dma interface support Doug Anderson <dianders@chromium.org> - 2015-08-16 23:20 +0200
      Re: [RFC PATCH v5 1/9] mmc: dw_mmc: Add external dma interface  support Shawn Lin <shawn.lin@rock-chips.com> - 2015-08-17 08:30 +0200
    Re: [RFC PATCH v5 1/9] mmc: dw_mmc: Add external dma interface  support Shawn Lin <shawn.lin@rock-chips.com> - 2015-08-17 03:20 +0200

csiph-web